RANCANG BANGUN MICROBUBBLE GENERATOR (MBG) UNTUK MENINGKATKAN OKSIGEN TERLARUT (DO) PADA BUDIDAYA PERIKANAN

Penulis

  • Citra Zaskia Pratiwi Politeknik Kelautan dan Perikanan Sidoarjo
  • Iman Mawardi Politeknik Kelautan dan Perikanan Sidoarjo
  • Faizin Adi Nugroho Politeknik Kelautan dan Perikanan Sidoarjo

DOI:

https://doi.org/10.15578/chanos.v20i1.11160

Kata Kunci:

microbubble generator, nozzle, dissolved oxygen, aquaculture

Abstrak

Microbubble generator (MBG) is one of aerator that used to enhance dissolved oxygen (DO). Microbubble generator is designed with the diameter of 45 mm for water inlet and reduced to the diameter of 10 mm. The air inlet has the diameter of 18 mm and increased to 45 mm so that it can be equal with the nozzle diameter. The nozzle is the outlet of water and air is reduced to the diameter of 22 mm. The test results showed that the minimum DO measured of 6.3 mg/l, and the maximum of 6.9 mg/l. The increase in DO ranged from 2.3 – 2.7 mg/l. The measured electric motor temperature ranged from 45°C - 55°C for 9 days of testing so that it can be stated that the microbubble generator can be used for 1 cycle of aquaculture. 

Referensi

Afisna, L. F. et al. 2017. Performance of Porous-Venturi Microbubble Generator for Aeration Process. J. Energy, Mechanical, Material, and Manufacturing Engineering, 2(2):73–80.

Budhijanto, W. et al. 2017. Application of Microbubble Generator as Low Cost and High Efficient Aerator for Sustainable Fresh Water Fish Farming. American Institute of Physics, 1840:110008-1-110008-8.

Nugraha, R.S. 2014. Pengolahan Air Tanah dengan Proses. Surabaya: Doctoral Dissertation UPN Veteran

Nuryati, Dwiartomo, B., dan Ruswadi, A. 2019. Analisis Daya yang Dihasilkan Turbin Angin Tipe Windmill pada Sistem Aerasi Tambak Udang. J. Teknologi dan Rekayasa Manufactur, 1(1)

Rofik, D.A, Kardiman, Sumarjo, H. J., dan Noubnome, V. 2020. Perancangan

dan Analisis Alat Microbubble Generator (MBG) untuk Aerasi Kolam Ikan Tipe Nozzle Venturi. J. Infrastructure & Science Engineering. 3(2):24-30

Rosariawari, F., Wahjudijanto, I, dan Rachmanto, T. A. 2018. Peningkatan Efektifitas Aerasi dengan Menggunakan Microbubble Generator (MBG). J. Envirotek. 8(2)

Sadatomi, M., Kawahara, A., Kano, K., dan Ohtomo, A. 2005. Performance of New Microbubble Generator with a Sprical Body in Flowing Water Tube. Experimentall Thermal and Fluid Science, XXIX(1):615-623.

Sadatomi, M., Kawahara, A., Matsura, H., dan Shikatani, S. 2012. Microbubble Generation Rate and Bubble Dissolution Rate Into Water by a Simple Multi Fluid Mixer with Orifice and Porous Tube. Experimentall Thermal and Fluid Science, XLI(1):23-30.

Sadatomi, M., Kawahara, A., Matsuyama, F., dan Kimura, T. 2007. An Advance Microbubble Generator and its Application to a Newly Developed Bubble-Jet Type Airlift Pump. Multiphase Science and Technology Science, XIX(1):323-342.

Unduhan

Diterbitkan

2022-06-22

Terbitan

Vol 20 No 1 (2022): Chanos chanos

Bagian

Articles

Lisensi

Authors who publish articles in Jurnal Penelitian Chanos Chanos agree to the following terms:

  1. Authors retain copyright of the article and grant the journal right of first publication with the work simultaneously licensed under a CC-BY-SA or The Creative Commons Attribution–ShareAlike License.
  2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.
  3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).